I expect there is really nothing wrong.
It is most likely that you bumped the 'display voltage' slide switch on the
top of the Control Board during the firmware install. Check and move it
back to the INT position. I believe it will 'cure' the problem.
Newer K2s (3000+) have a jumper instead of the switch because of this
situation.
73,
Don W3FPR
----- Original Message -----
Since I installed the latest software on KSB2 I realize frequently " low
batt" message at the diplay of my K2.
Anyone got the same problem or have an idea?
Ser.Nr. 1020,
Greetings out of the snowy cold northern Bavaria.
73 de DG9NCL
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
