Gordon:
Also, the current drain depends on your input voltage. With a slightly
drained battery showing 11.9 volts on the K2, my current drain on 40M is
about 2.2 Amps. At 13.8 volts (showing 13.0 on the K2), it is 2.0.
John AA0VE
W3FPR - Don Wilhelm wrote:
Gordon,
2.2 Amps is probably OK - it is only 10% above the nominal, and that
is within the range of acceptable tolerance for an assembly of 5%
tolerance parts.
----- Original Message -----
I am almost done assembling #3108. During the 40 meter Transmitter
Alignment (page 72) the radio is drawing 2.2 amps for 10w power. The
manual
says "much higher than 2 A" is a problem. Is 2.2 a problem?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
