Just finished the KAT100/KPA100/EC2 and experience some trouble. At unpredictable intervals during transmission the KAT100 relais detune, the PWR Range LED jumpes to LOW (allthough output is still ok). Seems like a stray RF problem and I was looking in that direction. Tried to improve the earth to the rig, without result. Tonight I hooked up a dummyload to the tuner output. Seems to take longer, but even with the dummy connected the problem occurs: Klick.... Led to LOW, sometimes a message on the k2 display, but most of the time just tuner detunes and LED change. Has anyone experienced this? Should i do someting within the KAT100/KPA100? Any suggestions more than welcome Dick PA3CW [EMAIL PROTECTED] _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
