Hello all.
Working on the SSB adapter for K2/100 #4684 and have come up against
problem. I have continuity between all four pads of T1. The toroid
itself check out while out of the board. No shorts. The short only
happens when the toroid is soldered in the board.
I have removed it twice to make sure the insulation between turns is
intact and don't see any bridges on the board.
A swift kick in the right direction would be appreciated.
--
R. Kevin Stover ACØH
Reclaim Your Inbox!
http://www.mozilla.org/products/thunderbird
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
