Gerhard,
Do NOT scrape the tinned pads. Your problem is due to insufficient heat.
I hope you are using an adjustable soldering station.
Increase the heat to 400 degrees C.
Good luck!
73, Bob VE3XM
K2 S/N 02676
K2/100 S/N 04031
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
