Jim >From your description, it sounds like you are in SPLIT mode. Check the manual for directions. Good luck and 73 Bob N6WG
-------------- Original message -------------- > I bought a k2/100 from someone on this list several months ago, and > shipped to my remote QTH in CA. Just got out here to play with it > last weekend. It works fine on 160, but on 40 (and probably other > bands, haven't had time to check) the tuning knob tunes makes the > frequency readout change but the transmitted frequency (as observed > on another radio) doesn't. The readout said 7002 kHz, but the > transmitted (and receive) freq was around 7070. > > Any ideas what could be causing this? Some operational settings I'm > forgetting about? > > Other "glitches:" > > Tuning knob is VERY stiff compared to my own K2. Don't have tools > with me to work on it here to diagnose cause. > > Strong transients when the RF gain knob is turned (sounds like DC on > the pot from a leaky cap). Causes the AGC line to essentially mute > the radio for a second or so, then recovers to where the knob sets > it. > > Any ideas on these things? > > Jim K9YC > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
