Dear All, Page 47 in the (error) manual says: Adjust R1 on the control-board to 3.8 V. I can only reach 3.6V at pin 1 of U2 ( R1 is fully turned counter clockwise). With no signal at the antenna (IF-Gain MAX) i have 3.58 V at pin 1 of U2. With iF-Gain at MIN i have the 4.6V. This seems ok. But the AGC @Saturation is only 4.6V, far away from the expected 6.9V. The radio sounds good. The DC-voltage at U12, Pin 5 is only 3.8, not the expected 5.0. Is there anything wrong? Thanks for your help!
Michael, DC0ZO K2 #4691 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
