In a message dated 12/02/05 20:13:17 GMT Standard Time, [EMAIL PROTECTED] writes:
All of the checks were in the expected range, except for U6 pin 8, which was 36.8 ohms instead of greater than 100 ohms --------------------------------- Check that RFC14 on Q19 source has been fitted to the correct position. There is an adjacent ground through hole that if used by mistake will reduce the U6 pin 8 (8B rail) reading by 270 ohms as R20 then is effectively shorted out. Otherwise it is a matter of breaking down the direction of the loading of this reading. There are series resistors in some of the paths that can assist to this end. Bob, G3VVT _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
