Paul, I use a RASCAL with my K2. I originally bought it to use with a now dead Kenwood TS930 with an 8-pin mike connector, which is the same as the K2.
When I built my K2, I set-up the jumpers on the front panel board to use with my Kenwood mikes. The RASCAL works great in this configuration. This interface uses only the Audio, PTT and Ground Lines on the mike plug. The cable you will need depends on how you configure the K2 mike connector. Any RASCAL model that has the 8-pin round mike connector and 3.5 mm speaker plug should have all you need. You will have to match the connections on the cable to your K2 mike configuration. If you have any additional questions, post a message here with how you have, or intend to configure the mike input on your K2, and I or somebody else should be able to help. 73, Mike -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of designer Sent: Friday, February 18, 2005 1:11 PM To: [email protected] Subject: [Elecraft] what cable with RASCAL PSK interface If you are using the K2 with the RASCAL interface for PSK, which cable did you order with the RASCAL. Thanks. 73, Paul _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
