You are OK. Anything 8.8 kHz or higher is OK. This is noted on the
builders web page at http://www.elecraft.com.
73, Eric
MikeH wrote:
Hello Group,
I'm building my first K2, purchased about two months ago, and I've hit a
little bump during alignment and test (part 2).
During the PLL Reference Oscillator Range Test I came up with too narrow
a range (9.37 kHz somewhat below the 9.8 minimum)). My high freq. ref.
during the test was 12099.95, and the low was 12090.58). I gather that
my low point is not low enough. I did check the components listed in the
trouble-shooting section (D16, D17, C84, C85. L31) and they are ok. I
have also checked all soldering, and it looks fine.
Anyway, as always, helpful comments are welcome.
Mike/NR7F
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
