Hi Elecrafters, just finished my XV50 and hooked everything up with my K2. So far all is fine, but I have a strange problem with the XV50:
I have set the t-r time to 0.05 s (semi break-in) and every now and then the XV50 goes into IF overload condition (all LEDs flashing). As I couldn't believe my K2 would do hot switching I set K2 in TEST mode (no output power) ... AND ... with 0.0 mW my XV50 still goes into IF overload condition. This doesn't happen regularly, but it does happen too often to ignore. Of course I could go to longer t-r times and forget about listen between the letters, but I don't believe my XV50 does behave normal. Did anyone else here notice this? PS: Of course 8R is set to hold, keying speed around 20 WpM, but the speed doesn't seem to have any effect. VY 73 de Marcus, DL1EKC _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
