Hello; New to list and just at alignment and test part III, page 74. I have been getting exceleent suggestions from Gary at Elecraft but was wondering if any of you had any similiar problems.
When I power up to do the test on Page 74 My rig is keyed up. Power output is 4 watts. Even when I reset using 456 at power up, same thing. Another Ham Chuch had diode d1 in the TR switch backwards that produced this same problem, I checked mine and all is well. Up to this point all alignment and tests worked perfectly, and assembly smoothly. I am using Torroids from the torrid Guy. I know that I will have to go back and set everthing else back up since I did a reset but this power output thing is preventing that. I also do not have the key closed on the Transcceiver and have measured the required 84K to ground to verify that this is so. Curious though if I hit the XFIL button to so to FL2, 3 or 4, The rig acts normally and all functions work and the power output stops, and the rig works peerfectly. But when reset and it goes to startup I see Elecraft for 2 seconds, followed by the keyer speed and PO=0.1 even though the power output is 4 watts at this stage. Any help would sure be wonderful thanks to all 73 Bruce N9BX _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
