Roland, That sounds like the behavior one would see if the control board is not properly plugged in.
Since you received the kit partially built, you should first gain confidence in what the previous builder has done. I suggest that you go through the steps in the manual (starting at the beginning) and recheck everything - component values, proper orientation of components, and the soldering of each component. I know it is a large task, but is the only way I know to check things. Chances are very good that the components are not at fault - the most common cause of problems is improperly soldered connections, second is incorrect components (or incorrectly located components). Actual component failures are way down on the 'trouble' list - they may fail, but that is rare. 73, Don W3FPR > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Roland & Elvie > Whitsitt > Sent: Saturday, February 26, 2005 10:12 PM > To: [email protected] > Subject: [Elecraft] Blank display on 1st power up > > > I just did the 1st aliment "smoke test". Put power to it for the > first time. When I turn it on, after a second, something clicks. > The display is lit but nothing else. No letters or anything. > Now what? I wonder if it's one of those main chips. I got this > kit partially assembled in a box. > Thanks for any help. > Roland in Stockton, Ca. > N5VWN > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
