Jim Harris wrote:
On the front panel board while trying to add SSB
components after the fact I managed to slightly burn
the edge of a push button. Wish the instructions had
mentioned to put the low SSB components in before the
higher and vulnerable parts were added.
Having just been through that part of the build too, I agree with Jim...
the top-of-board soldering for the KSB2 connector is is just the dickens
to do with the plastic pots and buttons in place; I made it through
without toasting anything but it would have been *so* much easier to do
before the top got crowded with tall meltable things. Is there a
reason this is where it is in sequence other than "Uh-oh, they're about
to mate the FP board to the panel and wire the enccoder; drop in the
KSB2 parts now because it will be inconvenient later"? If not, I say
move it to someplace earlier.
Another suggestion: Whenever you cue the installation of the KSB parts
on the FP, repeat the warning about component height/lead length for Q3
that was issued for Q3 and Q2...I forgot about it and I had to monkey
with Q3 after installation to allow the FP board to fit properly against
the metal panel.
I'm still delighted with the kit, of course...
73 de Maggie K3XS (K2 S/N 1641), who needs to go get more solder in
the morning; that "no-lead" stuff with silver in it stinks.
--
-----/___. _)Margaret Stephanie Leber CCP, SCJP/"The art of progress /
----/(, /| /| http://voicenet.com/~maggie SCWCD/ is to preserve order/
---/ / | / | _ _ _ ` _ AOPA 925383/ amid change and to /
--/ ) / |/ |_(_(_(_/_(_/__(__(/_ K3XS / preserve change amid/
-/ (_/ ' .-/ .-/ ARRL 39280 /order."-A.N.Whitehead/
/________________(_/_(_/_______AMSAT 32844_/<[EMAIL PROTECTED]>/
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
