Joe Jones wrote:
This K2 will be operating within 2m of a single cylinder diesel engine that
has a pronounced 'thump'/low frequency vibration - crockery left on the
draining board some 5m forward of the engine is liable to make its way back
into the sink!.
My feeling is that due to the low mass of the toroids, you will not need to do
this, especially since it's a thump and not a buzz. But...
Two part epoxy?
I wouldn't. Too permanent.
Superglue?
Difficult to use since there will be very little contact area between the wires
and the board. Also might be more permanent than you want.
Silicone Sealant?
ONLY if you can get the kind that doesn't emit acetic acid when it cures! The
regular stuff can be quite corrosive.
Again, I wouldn't do this.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
