Hi all!
I´m right now getting near the end of my K1-project. Receiver works like
a dream, but I think I´m getting mad when I´m trying to get ANY power
out from the transmitter. The output meter shows P 0.1 and my WM-2
wattmeter shows 0.000 mW....
I started to suspect that something was wrong with some of the toroids
and I rewound and resoldered T4. Did the tranmitter alignment afain on
10 MHz, and BANG! There it was! 2 watts of output power. I tapped the
MSG button and pushed the two WPM buttons again to continue the
alignment. No problems att all. I felt satisfied when the WM-2 showed
roughly 2.2 watts of output and the the K1 display showed 2.5 watts.
That called for a celebration, so I tapped the MSG button again to abort
"Tune" and went out to make myself a well diserved cup of coffee. I was
out for about ten minutes and went back to the shack to continue with
the transmitter alignment on 7 MHz. I just wanted to make another check
on 10 MHz and I pushed the two WPM buttons again... K1 display showed P
0.1 and the WM-2 showed zero output.
Now, what´s going on here? Is the rig re-aligning itself when nobody is
looking at it or..?
Think I´m going insane here...
Hans / LA2MOA
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
