Must be. I just looked at my board and the parts layout is missing the
"+" designator as well. Just powered things up and seems okay anyway.
I'm sure I put the long lead in the square hole like the rest of them.
Let me see, it looks like the "-" stripe is on the right side of the cap
when it is installed and facing the front of the RF board.
I'm just in the process of final alignments. Lots of fun so far! Too
bad I have to go to bed now and finish tomorrow, then start making QSOs
sometime tomorrow night!
Mark, NK8Q
K2 4786
Paul Bruneau wrote:
Hi Gang-
K2 #4818 here, Control and Panel boards complete, working on the RF
board, but C111's polarity isn't marked on the board or in the manual!
I assume that the square pad is positive and the round pad is
negative, but I don't really want to assume...can anyone verify for me?
Thanks,
Paul
KB8NMZ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
