Good going, Ken! Can't wait till I'm saying the same about #4834.
I've noticed a few notes regarding L31, and I'm not at that point yet in
my K2 build. It seems the concensus is that 12 uH should be used rather
than 10 uH in the notes I've read, so I wonder why the kitted component
was changed. Any recommendations on whether or should use 12 uH from
the start or better to try the supplied one first?
Thanks,
Mike AB3AP
Avondale, PA
Ken K3IU wrote on 03/23/05 19:13 ET:
Hi Gang:
Finished up the basic K2 (S/N 4830) this afternoon with no problems except
for the VCO range which was below minimums. Fortunately, I had a 12uH
inductor for L31 from an earlier project so that went in and solved the
problem.
Still have a couple of boxes of options to get assembled. Much fun ahead!!
73,
Ken K3IU
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
