I just built a KX-1 and it works FB, I installed the 30-meter module
today and when I went to test it, there are no peaks on 40, 30, or 20m,
and the rig recieves no signals at all. Pin 15 on the CPU which goes to
+5V to turn the 30m module on, stays at 0V. I finally removed the 30m
module and now the KX1 works fine again, re-aligned it on 40 and 20 and
it's back to its excellent self. I checked the diodes on the 30m module
and they seem ok, forward drop is the standard .62V you get with Si
diodes, anyone have any ideas? Are there any of those wires that go
from the 30m module to the main board that are easy to mix up? Thanks
in advance, NS6Y
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
