Lee, I don't believe there is an article on using the matched crystals. Somewhere about SN 2600, Elecraft tightened the crystal spec with their vendor to control the motional inductance parameter, resulting in crystals better suited for filters.
Just replace the filter crystals and ground the variable IF crystals on both sides near the bottom of the can - then do the CAL FIL process to line up the filter passbands. The double grounding is mentioned in the A to B mod instructions. You will usually find a great improvement by changing to the newer crystals - but there are a few cases where the old crystals were good performers too, it was ust the 'luck of the draw' and depended heavily on the particular manufacturing batch. 73, Don W3FPR > -----Original Message----- > > I have gotten a hold of some matched crystals for both > > CW and SSB. Where is the article of the information > concerning what the matched crystals are suppose to > do. Also, what is the latest on grounding the crystal > cans. Any information would be interesting. > > Lee - K0WA > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
