i have the same problems OE6KYG
>>-----Ursprüngliche Nachricht----- >>Von: [EMAIL PROTECTED] >>[mailto:[EMAIL PROTECTED] Im Auftrag von [EMAIL PROTECTED] >>Gesendet: Mittwoch, 30. März 2005 05:42 >>An: [EMAIL PROTECTED]; [email protected] >>Betreff: Re: [Elecraft] KX-1 switches - anyone else having problems? >> >> >>In a message dated 30/03/05 00:09:46 GMT Daylight Time, >>[EMAIL PROTECTED] >>writes: >> >>One thing I have noticed on the KX1 is that the shaft >>encoder is a tad flaky ... sometimes I'll be tuning downward >>and the freq goes up one or two numbers in the least >>significant position. It sort of depends on how you hold >>the knob. A little pressure toward the top will increase the >> flakiness, toward the bottom will cure it. >> >> >> >>--------------------------------------------------------------------- >> >>I had an Alinco DX70 for repair recently where the sub dial >>gave a very similar result. On this the parts of the shaft >>encoder are held together with two split tabs. Over time >>these had slackened off slightly and allowed the encoder to >>flex slightly. Was able to reduce the effect by mechanical >>tightning of these tabs, but the only full cure was to >>replace the encoder with a new one. Possibly the KX1 has >>similar problems. >> >>Bob, G3VVT >>_______________________________________________ >>Elecraft mailing list >>Post to: [email protected] >>You must be a subscriber to post to the list. >>Subscriber Info (Addr. Change, sub, unsub etc.): >> http://mailman.qth.net/mailman/listinfo/elecraft >> >>Help: http://mailman.qth.net/subscribers.htm >>Elecraft web page: http://www.elecraft.com >> >> _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
