Denny,
I have removed the KDSP2 and jumpered the two headers. I am beginning to think
in my case however that the problem is in the P5 connection on the RF board. I
lifted the KPA100 up, turned it over and rested it on a stack of books. After
connecting the K2 up in this open condition, there was no audio. When I
jiggled the female connector to J5, the audio was restored. I am going to
operate the K2 for a while in this open condition. If all goes well, I will
restore the KDSP2. Maybe I should make a longer audio cable to the KPA100 that
doesn't bind when going around the KPA100 shield cut-out. In my case routing
the audio cable around the shield may cause this cable to strain somewhat at
P5. Roy Morris W4WFB
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.2 - Release Date: 4/5/2005
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
