Hi all-
K2 #4818 here, I'm in Alignment and Test part II
Everything has gone great, my soldering is nice if I do say so myself,
I'm very careful with my parts, but I have an "issue" with the PLL
Reference Oscillator Range.
My High freq: 12099.03
My Low Freq: 12089.77
My range: 9.26
The book says it must be at least 9.8 and to "see troubleshooting". I
wish they had put a nice three digit number next to that note so I knew
where in troubleshooting to look, but even if I knew, I don't know what
I would do...
Is 9.26 really too low? And what is it too low for? I'm just a guy with
a soldering iron who knows most letters of morse code without peaking!
I have been continuing for now. VCO Alignment went fine. BFO test went
fine. If this is really a problem, where will I see the negative
aspects of it?
Thanks everyone, you all make one fine list!
-Paul
KB8NMZ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
