Remove K3 power by pulling the power plug. Wait about 30 seconds. Shut down the K3 Utility. Plug the radio back in, and turn it on with the power button. Then start the K3 Utility again and load firmware
Dick, K6KR Sent from my iPhone On Jul 29, 2010, at 9:21 AM, ANTNEE N3ANT <[email protected]> wrote: > > Hello All, I was updating my K3/100 with MCU 4.03 / DSP 2.60 when It stop and > reported a failure with the update...The screen on the K3 reads MCU L D and > the TX redlight is blinking. The K3 Utility reads the time and after the > time It reads(sent ";" at 38400 bps) I tried to and reload the K3 Utility > and the Win2K/XP/2000/Vista/Win7 (32 and 64 bits) Driver for the USB/Serial > cable...No Luck ! ! ! How would I reset the K3 to get out of the MCU L D on > the screen ? > > Thanks for any Help ! ! ! > > Antnee N3ANT > > K3/100 #2913 > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/K3-2913-Stuck-with-MCU-L-D-on-the-Display-tp5347542p5347542.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
