On 8/3/2010 5:51 AM, Bill W4ZV wrote: > > john-61 wrote: > >> I have a k3 with the standard 2.7 filter and a 400hz cw filter >> installed. The 2.7 is in slot FL3 and 400hz is in slot FL4. My >> question is when you are adjusting the width of the filter should the >> filter 3 number change when FL4 filter engages? When I adjust my width >> down from 2.80 down to0.05 it always shows FL3 on the display. >> >> > Yes it sounds as you have not enabled the filter in FL4. The easiest way to > check is to use the K3 Utility's Filter Configuration screen. > > 73, Bill > Thanks Bill but, but I have checked that already and even made sure in the config menu that FL4 is ON. FL4 shows to be on in both locations. Any other suggestions?
thanks agian John ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
