K3 s/n running v4.03 f/w KRX3 installed K144XV installed Have entered a local repeater freq/offset/pl tone into VFO A Output/K3 RX: 147.285, positive offset (147.885 Tx) pl 103.5
Have another local repeater output freq on VFO B: 146.760 Can hear both repeaters fine. Once I TX on VFO to use the first repeater (Txing on 147.885), the Sub RX readout changes to 147.760. (The MHz digits go to the same as VFO A.) However, if I use an HT to open the second repeater (146.760 output), The K3 can still hear it, even though the display says 1 MHz higher. So, it looks like a display shift, rather than actual operating frequency. This behavior is the same whether VFO IND is Yes or No. I understand that the K144XV uses different LO crystals for 144-146 vs. 146-148, and simultaneous monitoring of 2 freqs in separate segments would not be allowed. However, these two repeaters are both in the upper segment, and the firmware should allow this. Can anyone else replicate this behavior? -Bruce N1RX ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
