I often find the true solution is the simplest. Occam's Razor k4ia In a message dated 8/3/2010 3:47:13 P.M. Eastern Daylight Time, [email protected] writes: Thank you to those who have been trying to help me to get my new K3 to talk with N1MM. That issue is now solved. It wasn't until I thought I had checked and rechecked all configurations, both in N1MM and in the K3, that I finally became convinced it was not a software/firmware issue. In checking my serial cables, I found the DB-9 connector to the K3 had slipped partially out of the K3 connector. I simply reseated that connector (AND used a screw driver to fasten it to the K3 and the K3 immediately started communicating with N1MM again. I do appreciate everyone offering me very well thought out suggestions to solve this problem. Thank you all again 73, Tom - W4BQF
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
