Congrats, Bill. After you finish the build, then comes the real excitement.
I had the same issue with the phone jack. The common wisdom was that the board wasn't seated properly, which was not true. I just let it rattle, with no known ill effects. When I did the DSP board swap I snugged it up with pliers and didn't break anything. 73, Mike NF4L On 8/5/2010 2:31 AM, Bill Conkling wrote: > Hi, > > > > My K3/10 arrived today and I have 10 hours in so far and am going to bed. > Next step is mouthing the speaker. My fingers are not as nimble as they > used to be but so far, I've only dropped three items, a screw, and two > washers. All retrieved. The resistance checks were ok and the power-up > went well. > > > > The only concern now is that phone jack doesn't pull up tight to the front > panel and the washer rattles. > > > > Off to bed, get up in the morning and finish up. > > > > :Looks real nice so far. > > > > ...bc nr4c > > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
