Eric, There may be space in that particular location, but there are reliability problems. Sockets provide an added chance of a poor connection at each IC pin.
The use of sockets in places where not specified is NOT recommended. I repair a LOT of Elecraft gear, and the instances where an IC is damaged and must be replaced is very low. Most problems stem from improper soldering and components that are in the wrong locations, diodes backwards, improperly tinned toroid leads, and improperly counted toroid turns. Use care when assembling your K1, solder in the ICs (except for the firmware chip) and it will work just fine when you are done. 73, Don W3FPR Eric Champine wrote: > Hi all. > I am at the point on the K1's front panel where I am supposed to solder in > the 3 "8 pin IC's" to the front panel. > The main chip has a IC Socket installed. I have extra 8 pin IC sockets in my > junk box. Is it OK to install the IC sockets or is there a problem with > space? > Thanks if anyone can help me. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
