Hi Gang, Just finished my XV432 expecting to use it next weekend in the ARRL VHF in my rover setup. Murphy has hit and maybe someone can give me a hand.
My setup is a K2/XV60/IO module running xverter duty with an XV222 using the split IF, Elecraft control cable, etc. I've used this for a few years and it works FB. Now for the XV432. I am on page 29 running Part VI-Filter Alignment. All is good up to the last checkbox at the bottom right of the page. I key the rig and get a 2V. On page 30, I continue with adjustment of L15, L16, L17. The readings are changing as expected. Then I go on to FL1 and FL2 to get a higher reading at TP5. At the first FL and turn of the screw, the voltage at TP5 goes to 0. And that is all. I cannot get volts at TP5. I checked to make sure the K2 is putting out power and I have milliVolts at the TX in connector. I did use a small metal Stanley screwdriver to make the fateful adjustment, but cannot see how this might matter. It would help to have a bunch of RF voltages to check to determine my problem. If I do not have this up and running by Thursday, my big rove plans will be shot as I've revamped the rover setup to include this transverter. 73, Mark K2QO FN03ra ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
