Phil, Greater than is defined as "greater than" - it can be as high as infinite = totally open circuit. The manual values consider that different DMMs will read resistances differently - particularly open circuit values.
73, Don W3FPR On 9/5/2010 11:49 PM, Phil Hystad wrote: > Gang, > > I am in the midst of putting together the KX1. I am at the first > intermission where a few resistance checks are performed. > > So, in one of these tests, it says that resistance checks of all other pings > of U1 (other then those explicitly measured already) should have resistance > greater then 10K ohms. Well, for almost every other pin, the resistance I > measure is not only greater then 10K but greater then 2 to 4 Meg ohms. I > assume this is OK since it satisfies the constraint. Is this a reasonable > assumption? > > For the D2 and D3 cathode resistance measurements I also read very high, > multi Meg ohm values, for a constraint specified as> 1 K ohm. I have made > measurements with S1 open and closed per the tests. My measurements always > agree to the stated constraint (e.g.> 1 K and> 10 K) but I measure very > large resistance values in the meg ohm range. Is this reasonable? > > Thanks for any comments or suggestions. > > 73, phil, K7PEH > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
