I am in section II alignment of my K2. I am not getting a signal from my
antenna jack to the output. I am using Tom Hammond's method of signal
tracing
using the lead of a capacitor attached to a clip that is attached to an
antenna. I have a signal when injected at the following test points;
c143, c141, c53, d6,
and c5. Then at c4 I have a signal on the right hand lead (away from the
board edge), but no signal on the left hand lead (near the board edge).
I have already
replaced c4 with a new 820 capacitor, but still no signal at that point.
Could you point me in the direction that I need to go next?
--
73 & God Bless,
Ken/NO4D
http://webpages.charter.net/kgk
Ambassadors For Christ Net +/- 7.280
M-F at 2:00 EST Sat at 2:30 EST
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
