Dan, See the manual page 57. If you have LIN OUT = Phones, the output level will be controlled by the AF Gain Control. Set it to "nor" which will be a fixed level dependent only on the menu parameter value.
73, Don W3FPR On 9/12/2010 7:43 PM, Dan wrote: > I am having the same problem. Hooked up to Line Out, set LIN OUT = nor 010, > but line output still dependent on AF gain setting. Only have main RX, not > SUB installed. > > Works well with fl Digi, but must set AF gain for it to work. > > Anyone else have any ideas? > > Dan, NM3A > > > > Denis Jackson-2 wrote: >> Fairly new K3 owner here - just getting set up for digimodes. I'm >> probably doing something stupid but... >> >> I can't seem to make line-out do what it should. I have visited "lin out" >> in the Config menu and set a value (10) rather than =phones and yet the >> level on the line-out jack is still dependent on the front panel AF Gain >> control. >> >> Any ideas what I've missed? >> >> 73 >> >> Denis MW0CBC / GW8OQV >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
