P3: s/n 464 Firmware 00.32 Rcvd 9/14/10 K3: s/n 4521 Firmware 4.10 Rcvd 8/2/10 I have an old logging program that I do not want to lose or have to change. My first problem, because this program is so old (YPlog) was solved by selecting a Kenwood TS570D as the xcvr and setting the baud rate at 4800/1 stop bit. That works fine.
Today, W4TV published an email explaining how to reset the P3 baud rate from its default of 38,400 back to 4800. That works. Unfortunately CONFIG:RS232, when I change the baud rate from 38400 to 4800 and press MENU/CONFIG again, the baud rate change is not saved in the K3 and I can no longer connect to my logging program. The only work-around I have found so far is to turn off the P3, set the K3 CONFIG:RS232 from 38400 to 4800, then press MENU/CONFIG, then turn the P3 ON again, and all works correct. Will there be a firmware update that will allow the P3 and the K3 to be set at baud rates other than 38400 when BOTH the K3 and the P3 are turned on? I certainly hope so because this YPlog is the only logging program I have found in some 20 years that will allow me to send CW at speeds over 60 wpm without the CW stuttering due to I/O interrupts from a CPU. Thanks and 73, Tom - W4BQF
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
