Geo, It is likely something that "just happened" and is unrelated to the K160RX installation. However, is there any way that you can describe "distorted". I can think of many ways that a CW note would sound distorted, but a bit more information might be helpful to narrow the field of candidates.
If it a a "warbling" type of distortion, check RFC15 on the bottom of the RF board for continuity (use the ohmmeter, it will measure 5 volts on both sides even if open). 73, Don W3FPR On 9/15/2010 5:42 PM, [email protected] wrote: > Built and installed the 160 kit in my K2 (6911) today. After alignment it > works good on all bands transmitting on CW. But on all bands receiving cw > the cw tone is distorted! What could I have done? I removed the K160RX and cw > sigs still distorted. Geo/W2BPI > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
