I am assembling a K2 and up to putting components into the RF board it went very well.
My question relates intially to the bar graph. When I first tested it as shown on page 48 of the manual, the bargraph, worked perfectly, I could set both the lo and high positions. Now I have assembled the components into the RF board, as shown on Assembly Part 2. Unfortunately the Bargraph no longer operates. If I go back and check Cal S lo or S hi, I do not see anything on the bargraph. Unfortunately the receiver is also deaf, no receive noise at all, yes the audio appears to work as I can hear the CW spot tone. So ideas advice please.. My best wishes to Elecraft having lost Scott, he was very good to deal with. Regards to all. Ross ZL1WN ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
