I've not seen this, but your VFO B area is probably showing power supply voltage when a power level is expected.
Can you save your configuration with the K3 Utility, then perform parameter initialization (EE INIT) then restore configuration? EE INIT is described in the K3 Owners manual. Dick, K6KR Sent from my iPhone On Sep 20, 2010, at 1:50 AM, "Jeff Cochrane - VK4BOF" <[email protected]> wrote: > Hi everyone, > > I am attempting to do a TX Gain Calibration and every time that I have > attempted it so far, I get the following response from the K3 Utility. > > -------------------------------------------------------------------------------- > > > Starting 5 watt calibration > > Calibrating at 1.900 MHz > > Calibration power settled at "13.5 V ;" > > Elapsed time: 12 seconds > > Tx Gain calibration failed because transmit power did not reach the expected > value > > 5 watt calibration failed > > > -------------------------------------------------------------------------------- > > I get the same error if I bypass the 5 watt test and go straight to the > 50Watt test. > I have tried it with the radio running on a battery and with a regulated > power supply. > I am using the latest version of the K3 utility. > > Any idea's? > > Jeff Cochrane > VK4BOF > East Innisfail QLD > Australia > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
