I'm sure this is "user error," but so far this user fails to figure it out. This started happening right around the time I loaded the current firmware into both the K3 and the P3. When I tune or recall a memory in the K3, the P3 correctly displays the frequency and it appears to be centered within the brackets on the smallest scan. However, when I use either marker and line it up with a signal off the current K3 frequency and tap select on the P3, the end result on the K3 is off about a KHz and this also shows up on the P3 - ie the signal I thought I put the marker on is now showing up down from current frequency.
Any ideas? Yes, I have calibrated the P3 according to the instructions on p19 of the manual, and the transceiver settings are unchanged and specify K3. Thanks in advance.... Gary W2CS ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
