It is too embarrassing to tell. Tnx for reading :) > -----Original Message----- > From: [email protected] [mailto:elecraft- > [email protected]] On Behalf Of Gary Ferdinand > Sent: Thursday, September 23, 2010 12:33 PM > To: Elecraft > Subject: [Elecraft] P3 MKR off freq? > > I'm sure this is "user error," but so far this user fails to figure it > out. > This started happening right around the time I loaded the current > firmware > into both the K3 and the P3. When I tune or recall a memory in the K3, > the > P3 correctly displays the frequency and it appears to be centered > within the > brackets on the smallest scan. However, when I use either marker and > line > it up with a signal off the current K3 frequency and tap select on the > P3, > the end result on the K3 is off about a KHz and this also shows up on > the P3 > - ie the signal I thought I put the marker on is now showing up down > from > current frequency. > > Any ideas? Yes, I have calibrated the P3 according to the instructions > on > p19 of the manual, and the transceiver settings are unchanged and > specify > K3. > > Thanks in advance.... Gary W2CS > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
