While operating my K2, using the ATU with a balun for my 300 ohm twinlead-fed loop, sometimes I've suddenly noticed that my power out, while transmitting, is showing only two bars, instead of the five or six I should be seeing. If I hit tune, I sometimes get "nothing" - no bars, and the display says lo power. After trying a couple of things - switching bands, or holding TUNE and DISPLAY together, I'll get it to tune up and act normally again. Sometimes after getting it going again, it shows all ten bars lit up at first, then reverts to the five or six. I did just change R98 on the RF board from 270 to 1K, which mostly resolved my too-high power out problem.
Any ideas...? Thanks... LL/K3ESE 11+379+4442=KX1K1K2#4832 __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
