Tommy, I tried my RIT and I agree that the VFO A frequency appears to move as you turn the RIT knob. But if you transmit, the VFO A frequency reverts back to the original frequency. I suppose it might be better to keep the VFO A frequency the same and only show the offset +/- setting for RIT in the VFO B display. That might be less confusing. I never noticed the issue until you pointed it out.
Dave, N4QS ----- Original Message ----- From: "Tommy Alderman" <[email protected]> To: <[email protected]> Sent: Thursday, September 30, 2010 6:36 PM Subject: [Elecraft] RIT? > I'm not sure how this is supposed to work and I can not find an answer in > the K3 manual. When I first got my K3, I thought when I was tuning RIT > that > my receiver frequency changed but the VFO A display did not. Now when I > change RIT, VFO A frequency reading also changes and to me, this is > indicating my tx frequency is being shifted also. I have CONFIG:VFO OFS > set > to OFF and RIT CLR set to UNDO OFF. Can someone please tell me the > 'normal' > operation of RIT? > Thanks. > Tom - W4BQF > > -------------------------------------------------------------------------------- > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
