Owen, I will have to take some of the blame about the wording in the manual errata sheet. I had though specifying the outer holes of the set of three was sufficient - but I was apparently thinking only of a "set" in mathematical language terms (I am certain any mathematician would select the right holes from that statement), so Ron got approval and made the errata item that reads like yours. After hearing about several builders who still were having trouble, we decided to change the errata again to state explicitly that the middle hole of the 3 should be empty (or some wording to that effect). We hope this wording clears up the confusion once and for all.
73, Don W3FPR On 10/6/2010 5:31 PM, Owen B. Mehegan wrote: > Ah, so you did, Don. My mistake for not taking heed, I would have > pressed on with the signal tracing. However, while sitting here at work > and pondering the problem, I just re-read your message below for the 3rd > or 4th time, and something clicked: AHA! I _did_ put C6 in the wrong > holes!! When I realized you were specifically referring to a strip of 3 > holes it jogged my memory. There's even an errata about this, which I > dutifully added to the manual, but it still confused me. The errata > says: > > Add to the end of the step, "Use the outer of the three holes, not the > two holes closest to the left edge of the pc board." > > Somehow I just interpreted that as "use the two holes closest to the > right edge." Since I'm at work at the K2 is at home, I thought I would > have to wait to confirm my mistake, but I remembered that I sent some > friends a picture of the board when I finished it. I just pulled it up > in my email, and I can clearly see that C6 is in the wrong holes! > > I'll correct this tonight and see what that gets me. Thanks Don! > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
