Disconnect p3 power plug. Remove K3 power by pulling its power plug. Stop K3 utility. Plug k3 power back in and press K3 power on. Do not power on P3. Start k3 utility and load K3 firmware. Then restore P3 power.
Newest P3 manual has this info Dick, K6KR Sent from my iPhone On Oct 16, 2010, at 17:04, Phil Theis <p...@k3tuf.com> wrote: > Got new P3 and worked fine. > Went to load new firmware. > Gave error dialog that needed to turn off P3 > Turned off P3 > Now K3 is in mid stream says MCU LD > K3 Utility is just looping saying "Attempting to contact K3" at various > speeds. > Am I up the creek? > What is my next step to get K3 back? > Phil K3(352)TUF > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html