I am currently building my first K-2 (SN 4645) and have run into a
problem. I am going through the "Alignment and Test, Part II"( p 60 in
current manual) and specifically, I am doing the "VCO Test". All I get
is a reading of 0000 kHz when using CAL FCTR and the counter on TP1.
Also, when performing the next test "VCO Alignment", when adjusting L30,
I get NO change in voltage...it never moves from 8.3 V.
I rewound T-5, thinking that may be the problem, but that did not
help....no change.
Any help would be appreciated. Everything has gone smoothly until now.
This is GREAT fun!
Thanks
George
K2WO
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
