You could do that if you connected the PTT button of the mic to the
"KEY" input on the back of the K3, I suppose, but not otherwise
(AFAIK).
There is a TUNE function on the K3 - "hold" the "XMIT" button to start
tune, and tap it to stop. You configure this for either [nor]mal power
out, or a preset tuning power level via CONFIG:TUN-PWR.
Personally, I keep a spare footswitch connected to the KEY input, and
use that for amp tune-up at full drive power, and the TUNE function
for a low-power antenna-tuning signal.
~Iain / N6ML
On Tue, Oct 19, 2010 at 11:57 PM, <[email protected]> wrote:
>
> This is probably going to be a strange question but I'll ask it anyway. I
> don't have a cw key hooked up to the K3 as of yet. I finally have my
> microphone hooked up and all the alc and power levels set. In fact I made my
> first contact with the K3 on 40 SSB with WP2B. But I used to set my kenwood
> ts-480 to cw and would key the microphone and would be able to tune my
> antenna with my Palstar AT2K with no problems. But I don't know if I can do
> the same thing here on the K3. Any help would be very much appreciated.
> Mark KB3Z
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
