Just a thought, but a couple of dollars (less than $20 IIRC) buys a battery operated doorbell that uses a couple of alkaline C-cells that last for many years. Makes it very easy to add a second bell in a basement shop or garage that also rings, if needed.
Been decades since I had a doorbell transformer in the house. Ron AC7AC -----Original Message----- --- On Sat, 10/23/10, Phil Kane <[email protected]> wrote: > If you mean the doorbell transformer, the insulation dries out > and turns start shorting, leading to excessive heating and > internal arcing. They usually have an internal thermostat to > cut it off when hot, and after it cools down it starts all > over again. If that was true then why don't ALL transformers have thermal cutouts? Or stated another way, why are only doorbell transformers allowed to be built so cheaply that their insulation dries out and arcs? The thermal switch is there to protect against cheap doorbell pushbutton switches that occasionally get stuck in the closed/ON position, which is only supposed to be momentary. If that happens the transformer will heat up rapidly and the thermal switch opens to protect the circuit. Unfortunately, it looks like the energizing current in the transformer primary creates enough heat to open the switch just enough to arc and keep the doorbell operational. That's what's happening at my home...I really must replace my transformer again. 73, Ken Alexander VE3HLS ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
