Good evening, I've just started having a problem with the latest K3 Utility. When I run the utility without the rig turned on it tries to connect at each of the baud speeds as usual. If I turn the rig on (or indeed if the rig is already turned on when I launch the utility) the program finds the correct baud rate but then instantly locks up. The only way to exit s via the windows task manager.
Tried on multiple ports, multiple baud rates on K3 and USB adapter, nothing other than version of K3 utility changed since I last upgraded the firmware. Windows 7 64-bit happened with the previous version of the utility that was installed (hence downloading the new version). I'm a little perplexed as the rig control works fine with the logger on the same serial port. Any suggestions? 73, Iain M0PCB (patiently awaiting my new KX1 kit to clear customs...) ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
