The filter offset for 5-pole filters (like your 2.7 kHz filter) should be printed on a paper slip attached to the filter itself. The 2.1 kHz SSB filter is an 8 pole filter, and zero is the recommended offset for an 8-pole filter.
The recommended Loss Compensation (gain) settings for your 2.7 and 2.1 kHz filters are both 0. See K3 Utility Help. There's an index entry for "crystal filter configuration", and that help page describes the recommended offset and initial gain settings for filters offered by Elecraft. This help information is derived from the K3 Owner's Manual section under "Configuration", "Crystal filter Setup" starting on page 46. 73 de Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Monday, November 08, 2010 8:18 PM To: [email protected] Subject: [Elecraft] Crystal Filter Setup I noticed on the K3 utility program that there is a crystal filter setup. I see both my filters that are installed. They are a 2.7 and 2.1 SSB filter. I see that there is a filter offset and also a filter gain. What are the recommended settings for these 2 options? Any help would be appreciated. Mark KB3Z ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
