On 11/12/2010 7:43 AM, Tommy Alderman wrote: > Could someone please re-past the suggested TX EQ for the K3 when using the > Yamaha CM-500 mic?
Rear panel, bias on, Menu Mic Gain to low setting. TXEQ -- set two lowest bands to their minimum setting. Depending on your voice, you may also want a lot of cut in the third band. Do the third band by ear based on reports from someone listening with their RX filter wide. Set all other filters flat (zero, no cut, no boost). To set levels -- first, turn COMP all the way down, then talk and set front panel mic gain for ALC (indicated on the meter) to the marked level for ALC. THEN turn up COMP until you see 10dB of compression on voice peaks. Now you're ready for on-the-air signal reports. 73, Jim K9YC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
