Bob I certainly could have done that. In fact, before I powered it up the first time, I had done the same thing, but when I ran the K3 Utility, I corrected my error. Thanks for the suggestion. To all: I am working with Wayne and Gary currently trying to chase down the problem. Thanks everyone for your suggestions and good wishes.
Bob On 11/15/2010 11:25 AM, Bob Henderson wrote: > Bob > > I had a similar experience for a few minutes during set-up of my new K3. In > my case I had not installed a roofing filter at FL1, choosing instead to > leave a gap there for later installation of a wider filter. The firmware > default assumes a filter will be present at FL1 and the absence of one made > the RX deaf and provided 0W RF out on TX. Once I had changed the default > filter location, which I did using the Elecraft K3 utility, the RX came to > life and TX Gain Cal ran just fine producing the required 5W output on every > band. > > This might possibly be your problem. > > Good luck. > > Bob, 5B4AGN > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- 73, Bob K5SM ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
